Practically speaking, however, the far field can commence physically close to the radiating aperture, depending on aperture diameter and the operating wavelength.īeam divergence is often used to characterize electromagnetic beams in the optical regime, for cases in which the aperture from which the beam emerges is very large with respect to the wavelength. The term is relevant only in the " far field", away from any focus of the beam. 1.10 kV), whereas AOMs offer more deflection range, simple design, and low power consumption (less than 3 W).In electromagnetics, especially in optics, beam divergence is an angular measure of the increase in beam diameter or radius with distance from the optical aperture or antenna aperture from which the beam emerges. However, these require very high voltages (e.g. When faster control is necessary electro-optic modulators are used. This is fast enough to create active modelocking in an ultrafast laser. The time it takes an AOM to shift the exiting beam in is roughly limited to the transit time of the sound wave across the beam (typically 5 to 100 ns). Mode-locking Īcousto-optic modulators are much faster than typical mechanical devices such as tiltable mirrors. The acousto-optic tunable filter, especially the dazzler, which can generate variable pulse shapes, is based on this principle. The acoustic waves induce a birefringent phase-shift, much like in a Pockels cell. The phase can be changed by an arbitrary amount.Ĭollinear transverse acoustic waves or perpendicular longitudinal waves can change the polarization. In addition, the phase of the diffracted beam will also be shifted by the phase of the sound wave. In this case the spectrum of the diffracted beam contains multiple frequency shifts, in any case integer multiples of the frequency of the sound wave. In some AOMs, two acoustic waves travel in opposite directions in the material, creating a standing wave. A typical frequency shift varies from 27 MHz, for a less-expensive AOM, to 1 GHz, for a state-of-the-art commercial device. This frequency shift can be also understood by the fact that energy and momentum (of the photons and phonons) are conserved in the scattering process. The interaction can be thought of as a three-wave mixing process resulting in sum-frequency generation or difference-frequency generation between phonons and photons.Ī typical AOM operates under Bragg condition, where the incident light comes at Bragg angle θ B ≈ sin θ B = λ 2 Λ Incoming light scatters (see Brillouin scattering) off the resulting periodic index modulation and interference occurs similar to Bragg diffraction. These can be thought of as moving periodic planes of expansion and compression that change the index of refraction. An oscillating electric signal drives the transducer to vibrate, which creates sound waves in the material. A piezoelectric transducer is attached to a material such as glass. They are used in lasers for Q-switching, telecommunications for signal modulation, and in spectroscopy for frequency control. By vibrating the material with a pure sinusoid and tilting the AOM so the light is reflected from the flat sound waves into the first diffraction order, up to 90% deflection efficiency can be achieved.Īn acousto-optic modulator ( AOM), also called a Bragg cell or an acousto-optic deflector ( AOD), uses the acousto-optic effect to diffract and shift the frequency of light using sound waves (usually at radio-frequency). A light beam is diffracted into several orders. JSTOR ( December 2009) ( Learn how and when to remove this template message)Īn acousto-optic modulator consists of a piezoelectric transducer which creates sound waves in a material like glass or quartz.Unsourced material may be challenged and removed.įind sources: "Acousto-optic modulator" – news Please help improve this article by adding citations to reliable sources. This article needs additional citations for verification.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |